| SPECIFICATION
- ASTM D-41
- Fed. Spec. #SS-A-701
- AASHTO M-116
USESIt
is especially designed for use as a general utility prime coat for
concrete, gypsum, masonry, brick and metal surfaces over which waterproofing,
dampproofing, roof coatings and other asphaltic products are to
be applied. This thin solution readily penetrates pores and seals
dusty masonry surfaces to provide a firm base for such coatings.
It is specified as a prime coat previous to the application of the
membrane system of waterproofing on all concrete structures. It
is also very efficiently used as a felt primer on old dried out
built-up roofs where penetration is required to revitalize the base
surfaces before roof coatings or cold applied systems are applied.
SURFACE PREPARATIONAll
surfaces to be primed or coated with Karnak #108 Asphalt Primer
must be dry and free from oil, grease and any other foreign matter.
APPLICATIONEasily
applied by brush or spray equipment at the rate of 1/2 to 1 gallons
per 100 sq. ft. depending upon porosity and type of surface being
primed. Masonry and dried out built-up roof structures should be
liberally coated to obtain the most penetration so that an effective
bond can be achieved for the covering material.
COVERAGEApply
at the rate of 1/2 to 1 gallons per 100 sq. ft.
CARE OF TOOLSBrushes
and other tools may be thoroughly cleaned after use with mineral
spirits, taking the necessary precaution when handling combustible
materials.
CAUTIONDo
not use near open flame. Avoid breathing solvent fumes and prolonged
contact with skin. Do not take internally. If swallowed, do not
induce vomiting. Call a physician immediately. Keep out of reach
of children. Keep container covered when not in use. Do not thin.
Dispose of in an environmentally safe manner.
PACKAGINGAvailable
in 5 gallon pails and 55 gallon drums.
|
