Karnak Corporation

DESCRIPTIONKarnak #100 Non-Fibered Emulsion Roof Coating is a general purpose non-fibered emulsion roof coating prepared from an asphalt binder, carefully refined and emulsified in water by means of selected colloids. The asphalt emulsion thus produced is of heavy paint consistency. Karnak #100 Non-Fibered Emulsion Roof Coating is a tough, flexible black-asphalt compound especially designed to provide excellent protection to most roof surfaces against weathering. Karnak #100 Non-Fibered Emulsion Roof Coating will not burn or support combustion in a liquid state. It has no odor or fumes, and resists the absorption of exterior moisture.

SPECIFICATION

ASTM D-1187 Type II
ASTM D-1227 Type III, Class 1
SS-R-1781
MIL-R-3472A

SURFACE PREPARATIONAll surfaces should be clean and free from oil, grease, rust, dirt and other foreign matter. Excess water should be removed, if possible, before application of Karnak #100 Non-Fibered Emulsion Roof Coating.

APPLICATIONKarnak #100 Non-Fibered Emulsion Roof Coating is easily applied by brush, roller or spray equipment.

BRUSH APPLICATION: Apply with a wide fiber brush at the rate of 2 to 3 gallons per 100 sq. ft.

SPRAY APPLICATION: Utilize a standard heavy duty spray pump using heavy duty guns and nozzles. Apply at the rate of 2 to 3 gallons per 100 sq. ft. Equipment manufacturer should be consulted for more complete information.

COVERAGE RATEApply at the rate of 2 to 3 gallons per 100 sq. ft.

PHYSICAL PROPERTIES

Weight per Gallon: 8.5 lbs
Solids by Weight: 56%
Solids by Volume: 58%
Color: Brown Wet-Black Dry
Permeability: 0.5 Metered Perms
Dry Time: 4 to 6 Hours
Service Temperature Range: 0° to 180°F

CARE OF TOOLSTools and other equipment should be cleaned with water immediately after use. Dried material may be cleaned with mineral spirits. Take necessary precautions when handling combustible materials.

CAUTIONDo not apply when rain is imminent. Protect from freezing. Coating must be dried before exposure to water. Store in a heated room and keep container covered when not in use. Keep out of reach of children. Do not thin. Avoid prolonged contact with skin. Dispose of in an environmentally safe manner.

COLD-PROCESS SYSTEMS AND COATINGS, EITHER EMULSION OR SOLVENT BASED, SHOULD ONLY BE INSTALLED ON DECKS WITH POSITIVE DRAINAGE.

PER NRCA, (NATIONAL ROOFING CONTRACTORS ASSOCIATION) "THE CRITERIA FOR JUDGING PROPER SLOPE FOR DRAINAGE IS THAT THERE BE NO EVIDENCE OF STANDING WATER ON THE DECK 48 HOURS AFTER IT STOPS RAINING."

PACKAGINGAvailable in 5 gallon pails and 55 gallon drums.